Skip to content

Common questions

Straight answers about arena sand.

Most arena footing advice is written by companies selling something to put in it. These are the questions we get on the phone, answered the way we answer them on the phone.

Start here

The six behind most calls.

Nearly every call we take is one of these six questions wearing different clothes. Each one is a full guide.

Everything else

The rest, by theme.

7 of them open right here for a thirty-second answer. The other 12 are articles, one question each, traced back to what is causing it.

01

choosing the material

Which sand, and which names on a quarry list to walk away from.

2 open here · 3 articles

Washed, screened, sub-angular silica sand with a low percentage of fines. Those are separate properties, and a good arena sand has all of them.

Sub-angular grains nest together enough to give traction without packing like fully angular sand. Washing and screening keep the fines low, so the surface drains and does not turn to dust.

Quartz resists breaking down under hoof concussion. Beyond that it depends on your discipline, your climate and how much you ride. That is the part no chart can answer for you.

Usually not, and this is the single most expensive mistake in arena building. Those names describe what the sand was graded for, not how it behaves under a horse.

There is no such thing as a universal 'arena sand'.

Nobody keeps a register of sand names in the US, the trade's own estimate runs past 10,000, and only a narrow band of them belong in a riding arena.

02

how much, and how deep

Depth is a soundness decision. Tonnage falls out of it afterwards.

2 open here · 2 articles

Most arenas land between 2 and 4 inches. Penn State Extension recommends starting at 2 inches and adding in half-inch increments until it rides right.

That advice is worth following, because taking sand out is far harder than putting more in. Published guidance advises against going past about 6 inches, because of the strain deep footing places on tendons.

A full-size 100 × 200 ft arena at 3 inches deep is 250 tons, about 12–14 truckloads. A 60 × 120 ft private arena at the same depth is 90 tons, or 5 loads.

Both are figured at a flat 100 lb per cubic foot, with nothing added for settling.

03

something is wrong with it

Dust, hard packing, standing water. Start from the symptom.

1 open here · 4 articles

Three usual causes. The sand is breaking down under hoof concussion into particles fine enough to go airborne. Or it was never properly washed and still carries clay, silt or organic material.

Or your base is migrating up through the footing. Dust is usually a sand problem before it is a watering problem, which is why the fix starts with knowing what you actually have.

04

cost, sourcing and delivery

What moves the number, who to buy from, and what turns up on the day.

2 open here

It depends on far more than the sand. Freight is frequently the largest line on the invoice, so the distance between you and a suitable quarry usually matters more than the material itself.

Tonnage, truck type, site access and whether the sand needs washing or screening all move the number. We'll give you a real figure once we know where you are and what you need.

We source nationwide. We don't own quarries or trucks.

What we do is know which sands work, which quarries have them, and how to get the right material to your arena without you having to translate a gradation report yourself.

Free quote · by phone

Not the question you came with?

Send it over and we’ll answer it properly, and it stays between us. Or call and describe your arena. That is usually faster.

Call (704) 310-6238