Skip to content
← Common Questions

The jar test · free, and yours to run

How to test your arena sand.

A jar, some water and a day of leaving it alone will show how much of your footing is sand and how much is fine material. Six steps, and we will be straight about what it cannot answer.

Before you commit an afternoon

What this test is.

Shake sand and water together and the contents sort themselves by weight. What stacks up is a picture of how clean your footing is.

what it costs
Nothing you do not already own
how long
Minutes to set up, a day or two to finish
what it answers
How much of your footing is fine material
what it misses
Grain shape, size spread, mineral hardness

Fine material is behind two of the complaints we hear most: an arena that dusts and one that will not drain. Looking at it needs no kit and nobody’s permission.

Step zero

Fetch this, dig there.

The two things people get wrong are sampling from one spot and not shaking it long enough. Both are settled before you start.

What you need

  • A clear jar with straight sides and a lid
  • Sand from four or five spots around the arena
  • Water
  • One drop of dish soap
  • A marker or a strip of tape
TRACKTRACKCORNERCENTERQUIET ENDMIXONE JAR
Five handfuls, one jar. A scoop from the middle only ever tells you about the middle.

Do it this afternoon

Six steps.

Five of them take a minute each. The sixth is the next day.

01SAMPLE02A THIRD03WATER04SHAKE05WAIT06READ
The whole test in one row. Check your own jar against the panel for the step you are on.
  1. STEP 01

    take sand from several spots

    One scoop from the middle tells you about the middle. Pull a handful from four or five places, such as the track, a corner and a spot the horses rarely reach, and mix them.

  2. STEP 02

    fill a straight-sided jar

    Sand about a third of the way up. Straight sides matter: in a tapered jar the layers lie at an angle and you end up guessing.

  3. STEP 03

    top it up with water

    Nearly to the rim, leaving a little air so the contents can move. One drop of dish soap helps the finest particles let go of each other instead of settling as clumps.

  4. STEP 04

    shake it properly

    Lid on, shake hard for a minute or two until nothing is left on the bottom. An under-shaken jar reads cleaner than the sand really is.

  5. STEP 05

    put it down and leave it alone

    Somewhere level that will not get knocked. Agricultural extension services generally have you mark the sand layer after about a minute, the silt after a couple of hours, and the clay after a day or two.

  6. STEP 06

    read it from the bottom up

    Coarse sand at the bottom, finer sand above it, silt above that, clay last, anything organic floating on top. You are reading how much of your scoop is sand and how much is not.

Step five, drawn

Three marks, one day.

Everything falls at a speed set by its weight, so the layers arrive in order. Mark the jar as each one lands.

~1 MINMARK SAND~2 HRMARK SILT1-2 DAYSMARK CLAYSHAKEN
The intervals are not ours. They are the settling times agricultural extension services publish for reading a soil jar, and the physics is the same in arena sand.

There is no line on the jar where a sand stops being acceptable.

We could invent one. Plenty of pages do. A threshold only means something set against a real gradation report for the sand in front of you, and we will not guess at a figure for something going under a horse.

A thick band of fine material above the sand is a dust and drainage story waiting to happen. How much of one depends on your discipline, your climate and whether the arena has a roof. That part is a conversation.

Row by row

Reading your own jar.

The third column is the one worth reading twice. It is what an honest test leaves on the table.

A CLEANER SANDA DIRTIER SANDORGANICS FLOATINGCLOUDY WATERCLAYSILTFINER SANDCOARSE SANDCLAY STILL SETTLINGMOSTLY SANDLESS FINE MATERIALA DEEP BAND ABOVE THE SANDMORE FINE MATERIALTHE JAR SHOWS FINES · NOT SHAPE, GRADING OR HARDNESS
What each layer in a settling jar test of arena sand looks like, what it means for the footing, and what the test does not reveal
What you see in the jarWhat it meansWhat it does not tell you
A deep sand layer with little above itMost of what you scooped is sand. It arrived clean, or it was washed and screened before shipping.Whether those grains are the right shape, or hard enough to hold that size under years of hooves.
A clear band of silt over the sandA real proportion of fine material, the fraction behind dust when it is dry and water sitting on top when it is not.Whether the fines arrived with the sand or the sand is grinding them out of itself.
Water still cloudy a day or two laterClay. It stays in suspension longest, and it changes how a surface drains rather than just how it dusts.How the surface will ride once moisture is managed. That is an arena question, not a jar one.
Material floating on the surfaceOrganic matter: bedding walked in, manure that was not picked, leaves that blew in.Anything about the sand. This is a maintenance reading, and it is usually free to fix.
A sand layer that looks all one sizeLittle visible spread between the grains. Uniform material tends to shift underfoot instead of knitting together.The real gradation. Settling sorts by weight, not by sieve, so no jar gives a grading curve.

The part that gets left out

What the jar can’t tell you.

We are handing you a free test, so it is worth saying how far it goes. It answers one of the four questions that decide a sand.

01

grain shape

Rounded, sub-angular or fully angular decides whether the surface knits together or rolls underfoot. Two sands can settle out identically and ride nothing alike.

02

the spread of sizes

Settling sorts by weight, not by sieve, so the sand layer is not a gradation curve. One narrow size or a genuine range is a question for a screen.

03

how hard the mineral is

The big one. A soft grain grinds itself into new fine material every time a hoof lands, so a sand that tests clean today can spend years making its own dust.

Those three, plus the fine material the test does show you, are the four properties covered in choosing your sand. If your jar comes back clean and the surface still packs, start with why an arena packs hard.

If it says the material is the problem, the calculator turns your dimensions into tons and truckloads, and washed versus unwashed covers what washing actually removes.

Asked with a jar in hand

Jar test questions.

If yours is not here, give us a call and describe what settled out. Faster than any page can manage.

Minutes to set up and a day or two to finish.

Agricultural extension services generally have you mark the sand layer after about a minute, the silt after a couple of hours, and the clay after a day or two.

Heavier particles fall first, and the finest material stays up a long time.

We are not going to publish a number, and be careful with anyone who does without seeing your sand.

A threshold only means something set against a real gradation report for the material in front of you.

What the jar gives you is a comparison: a lot of fine material above the sand is a dust and drainage story.

How much of one depends on your discipline, your climate and whether the arena has a roof. That is a conversation, not a percentage.

Yes, and it is the best time. Ask for a sample off the actual stockpile the load would come from, not a handful from the office.

A stockpile is not uniform, so one jar is an indication rather than a verdict on the pile.

No. A sieve analysis sorts a dried sample through graded screens and reports what proportion sits in each size band. That is a gradation curve, made with equipment, to a standard.

A jar sorts by settling speed, which lumps together particles a sieve would separate. It is a good free look at your fines, not a lab result.

Usually not. Most barn owners get what they need from the jar plus an honest account of how the arena has been behaving.

If you are specifying material for a new build or a competition surface, the useful document is a gradation report from the quarry producing the sand.

We source sand and do not run a testing service.

Because a clean jar rules out one thing only. Fines are one property out of four, alongside grain shape, the spread of grain sizes and how hard the mineral is.

A clean, uniform, rounded sand can pass this test and still ride loose and never knit together. If fines are not the problem, the answer is in one of the other three.

Free quote · by phone

Tell us what settled out.

How deep the sand layer sat, whether a band sat above it, whether the water cleared, and how the arena rides. Usually enough for us to say whether the sand is the reason. And to say so when it is not.

Call (704) 310-6238